
Bostik Cementone integral waterproofer 2.5 liters

Bostik Cementone SBR Admixture White 5Ltr

Bostik CemenTech C1 Duo Crystallized Waterproofing Mortar 25Kg


Epochem 150 Descaler Liquid 5 Liters

Epochem 430 Rust Remover 5 Liters
GZ Industrial Supplies is the Distributors of Bostik Adhesive Products in Nigeria. This product Improves the workability and adhesion of mortars without adding lime. Minimises cracking, shrinkage and crazing and reduces water content of mortar.
Uses of Bostik Cementone Mortar plasticiser
Bostik Mortar Plasticiser (formerly known as Cementone Cemplas Mortar Plasticiser) is a blend of modified lignin- based surface-active agents free from chlorides. It improves the workability of mortar without the addition of lime. It helps reduce grittiness to provide a smooth easy to work mortar with improved durability and protection against frost. It also reduces the water content of the mortar. Bostik Mortar Plasticiser is suitable for use to improve mortars for applications such as; bricklaying, blockwork, and rendering.
Bostik Mortar Plasticiser has been designed to work with Portland cement: CEM I and Portland-fly ash cement: CEM II/B-V. For other types of cement e.g. Portland-limestone CEM II/A-LL it is recommended that a small trial is carried out to ascertain the optimum mix ratios as these cement types and sand can vary.
IMPORTANT: Do not use in concrete which is structural i.e. load bearing, reinforced, pre-stressed or steam cured. Work should not be carried out at temperatures below +5°C or when temperatures are expected to fall below this. Ensure materials and procedures comply with the appropriate British Standards. Do not exceed ratios stated. Do not overmix. Do not use with other admixtures. Do not add to lime based mixes. Do not use with high alumina, sulphate resisting or extra rapid hardening cement. Not suitable for floor screeds.
1. Ensure that all components of the mix are above 5°C.
2. Sands and aggregate should be dry for best results.
Shake well before use.
Add direct to dry mix in the ratio 85 – 90ml per 25kg cement.
When using Bostik Mortar Plasticiser 10 - 15% less water is usually required.
CLEANING
7. Clean tools and equipment immediately after use with water.
PRECAUTIONS IN USE
Bostik Mortar Plasticiser has been designed to work with Portland cement: CEM I and Portland-fly ash cement: CEM II/B-V. For other types of cement e.g. Portland-limestone CEM II/A-LL it is recommended that a small trial is carried out to ascertain the optimum mix ratios as these cement types and sand can vary.
Do not use in concrete which is structural, loadbearing, reinforced, pre-stressed, steam cured or contains embedded metals. Work should not be carried out at temperatures below +5°C or when temperatures are expected to fall below this. Ensure materials and procedures comply with the appropriate British Standards. Do not exceed ratios stated. Do not overmix. Do not use with other admixtures. Do not add to lime based mixes. Do not use with high alumina, sulphate resisting or extra rapid hardening cement. Not suitable for floor screeds.